New Garage Doors for Mattapan, MA Homes

New garage doors supplied and installed, and tired old doors replaced, on the detached garages at the end of Mattapan’s long driveways. Older wooden doors on their original hardware are the usual starting point.
  • Open 24/7
  • Homes & businesses
  • 5.0 on Google

Schedule garage door service

Tell us what’s going on with your door and we’ll get back to you.

Loading the form.

What customers say about Elite Boston

Real reviews from Google.

Loading reviews.

An older wooden overhead door, weathered and patched, on a detached single-car garage at the end of a long driveway

Why so many old wooden doors off River Street are due for replacement

On the side streets around Blue Hill Avenue and River Street, most single- and two-family houses keep a separate garage behind them, out where a driveway the full depth of the house comes to an end. Many of those garages still close with an older wooden door hung on 1950s hardware, and a fair number of those doors are reaching the point where repair no longer makes sense. New garage doors Mattapan MA homeowners ask us about are usually replacing exactly that: a heavy, weathered wooden door whose sections, springs, tracks and rollers have all been worked for decades.

Replacing a door like that is not only about the panel you see from the street. The old springs, cables, drums or pulleys, tracks and brackets come out with it, and the new door goes in with its own hardware, matched to its weight and to the opening it is going into. The garage behind the door stays the same, though, and its size, framing and condition shape what can be fitted.

Three signs suggest a door is worth replacing rather than repairing:

  • Wooden sections rotted through along the bottom, or split in more than one place.
  • A door so heavy with water and paint that it is hard to balance and wears out springs and openers.
  • Joints that have opened up so the door sags across the middle or twists as it travels.

What replacing an old door takes in

Taking out the old door

The old door is dismantled section by section, with its spring tension released safely first. Springs, cables, tracks and brackets come out with it.

Checking the opening

Width, height, headroom above the opening and room either side are measured, and the jambs, header and floor are checked for rot, movement and level.

Supplying the new door

A new door is chosen to fit the opening and the garage, and supplied with its own springs, cables, tracks and rollers sized for it.

Installing and balancing

Section by section the door is built up in the frame, its tracks set plumb and level, and its springs set so it lifts smoothly and stays put when stopped.

The opener

The current opener is assessed against the lighter new door. If it falls short, a new one can be installed. See our Mattapan opener repair page.

When an old wooden door has had its day

A wooden door can last a long time if it is kept painted and its moving parts are renewed, and plenty of them are still giving good service. Many of the repairs on our Mattapan garage door repair page are carried out on exactly those doors. But wood has a limit, and the doors on Mattapan garages face a great deal of weather at the head of an open driveway with nothing beside them to give shelter.

The bottom section usually goes first. It sits nearest the ground, where rain splashes up, snow piles against it and meltwater lies under the seal. Once the paint fails there, water gets into the end grain of the rails and stiles, and the wood softens from the inside. Hinges and the bottom brackets that hold the lift cables are screwed into that same timber, so rot at the bottom of the door is not just cosmetic: it is where the cables pull from, and a bracket that tears out of soft wood drops a corner of the door.

Weight is the other issue. A timber door carrying layer upon layer of paint that has also absorbed years of moisture can be considerably heavier than when it was new. Springs sized for its original weight cannot balance it, larger springs put extra load on old cables and hinges, and an opener attached to it works harder on every trip. When a door reaches the stage where it keeps breaking springs, wearing out rollers and straining the opener, a new door is often the better use of money than another round of repairs.

The opening behind the door

Every new door is sized to its own opening, and on a garage that has stood behind the house for decades, the opening needs a careful look before anything is ordered.

The jambs either side and the header above carry the tracks, the spring hardware and the door’s weatherstrip. If the wood there is soft, split or has been patched repeatedly to take new screws, it needs sorting out before a new door is fitted, otherwise the new tracks will be fixed into the same tired timber. Openings on older garages are also often slightly out of square, with one jamb leaning or the header sagging in the middle. A new door can be set to cope with small variations, but a serious lean has to be dealt with first.

The floor matters too. Many detached garages have a concrete or asphalt slab that has settled over the years, so the threshold is not level and may slope towards or away from the door. The new door’s bottom seal has to close against that floor along its whole width, and an uneven slab is noted at the measuring visit so the door can be set up to seal properly.

Headroom, meaning the clearance from the header up to the rafters or ceiling, decides where the springs and horizontal tracks can go. Some older garages have very little, especially where the roof is low or there are beams across the space. The room either side of the opening, and the depth of the garage behind it, also limit the track and spring arrangement. All of that is measured before a door is chosen.

A new sectional garage door being installed in the opening of a detached garage, with its vertical tracks fixed to the jambs

Choosing a new door

There is no single right door for every garage. What suits depends on the size of the opening, the headroom and side room, how the garage is used, and how you want it to look from the street and the driveway. At the visit the options that fit the opening are talked through, including the door’s style, finish and colour, whether it has windows, and whether insulation is worth having.

For a detached garage, some considerations are different from an attached one. An unheated outbuilding at the end of a driveway gains less from insulation than a garage attached to the house, though an insulated door can still be quieter, stiffer and more comfortable for anyone tinkering inside. Windows along the top of the door let daylight into a building that often lacks any glazing of its own. The colour and style are often chosen to match the house at the front of the lot, because the garage is seen at the end of the driveway alongside it.

Weight is worth thinking about, and it is one of the clearest gains from replacing an old timber door. The springs on a lighter door are smaller and calmer to work with, the cables and bottom brackets carry less load, and the hinges between sections are not being pulled apart by the weight of soaked wood above them. A modern sectional door is generally much lighter than an old wooden one of the same size, which means smaller springs, less strain on the opener and easier hand operation in a power cut. That alone is a big change for a garage where the old door had become a struggle to lift.

The choice of new garage doors Mattapan MA homeowners make should come down to the opening, the garage and their own preferences, rather than a standard package. You will see what fits before anything is ordered.

Garage door stuck or refusing to open?

Book a repair visit, ask about a new garage door, or call us now. We answer 24 hours a day.

What installation day involves

On the day, the work starts with the old door. Its spring tension is released safely, and only then does the door come apart, panel after panel, together with its springs, cables, drums or pulleys, tracks and brackets. On an old wooden door with extension springs and no safety cables, releasing the springs is done with particular care.

With the old door out, the opening is cleaned up and checked again. The new door’s bottom section goes in first, then the vertical tracks are fixed to the jambs and set plumb, and the remaining sections are stacked and hinged together. The horizontal tracks are hung from the ceiling or roof framing, the springs and cables are fitted, and the springs are set to balance the door. Rollers, hinges and the bottom seal are checked, and the door is run by hand to make sure it travels smoothly and stays put when stopped halfway.

Where the job includes an opener, this is when it goes up or is reconnected, with its travel and force tuned to the lighter door, the safety sensors are fitted and aligned, and the auto-reverse is tested by closing the door onto a block of wood. Before the crew packs up, you get a walk-through of the door and opener, how to use the manual release, and what to keep an eye on.

A long driveway and the delivery

A new door arrives as a set of sections, along with tracks, springs, hardware and, where needed, an opener. On a full-length driveway, all of that is carried from the street right down to the garage, and the old door and its hardware are carried back out. On a two-family lot where the driveway is shared and cars are parked along it, it makes installation day much easier if the driveway can be cleared before the work begins.

The garage itself needs space as well. The sections are stacked and assembled inside, the horizontal tracks run back along the ceiling, and the springs are fixed above or beside the opening. Clearing a working area just inside the door, and moving anything stored on shelves or hooks near the tracks, helps the job go smoothly. If the garage has a side door, have its key to hand.

Replacing the door in stages, or all at once

Sometimes the question is whether to replace only the door or the door and opener together. If the existing opener is in good condition and suitable for the new door, it may be reused, with its settings adjusted for the lighter door. If it is old, noisy, has no working safety sensors or was already struggling, replacing it at the same time saves a second visit and gives a door and opener that are set up together from the start.

When new garage doors Mattapan MA owners order are going onto a garage whose opening needs work, that work comes first. It is better to put new tracks and hardware onto sound timber than to fit a new door to a jamb that will give way before long.

A door for a garage two households share

Behind a two-family house, the garage is often used by both units: one parks inside, the other keeps bikes, tools or a mower there, or both have remotes. A shared door simply works harder than a door used by one household, and that is worth bearing in mind when choosing the new one. Hardware that suits frequent use, a door that is easy to lift by hand if the power goes, and an opener set up with a remote for each unit all make day-to-day life with a shared garage simpler.

It is also a good moment to tidy up the remotes. When a new opener goes in, only the remotes that are actually in use need to be programmed to it, so any lost or long-forgotten remotes for the old opener stop working. If the existing opener is kept, its memory can be cleared and the current remotes set up again.

Weather at the head of an open driveway

Standing alone where the driveway ends, the garage takes the weather head-on. Rain is driven straight at the door, snow is cleared off the driveway and banked against it, and in a hard frost the bottom seal can freeze to the slab. A new door does not change the weather, but it can be set up to cope with it better than the door it replaces.

The bottom seal is fitted to close against the floor as it actually is, which on an old slab may mean allowing for a dip or a slope. Fresh weatherstrip on the jambs and header is fitted to close the gaps that let rain and leaves blow in around the sides. A lighter door with correctly sized springs is also less likely to be damaged when it meets resistance from ice, because the opener is not working at its limit to move it.

Care after installation

A new door starts with fresh springs, rollers and cables, and some simple habits help them last. Keep the bottom of the door clear of ice and drifted snow in winter, so it is never asked to tear itself off the slab. Listen for new noises, such as a squeal from a roller or a scrape against a jamb, and mention them early rather than waiting. Watch whether the door still stays put when stopped halfway; if it starts to drift, the balance needs checking. And on new garage doors Mattapan MA owners have had fitted to a shared garage, make sure both households know where the manual release and the opener plug are.

When repair is still the better call

Replacement is not the default. If the sections are sound and only the springs, cables, rollers or hinges have failed, repair is usually the better value, and you will be told so. Spring problems are covered on our Mattapan spring repair page, and urgent faults on our Mattapan emergency repair page. A new door earns its place once the sections themselves, rather than the hardware, have failed.

Getting started

Planning new garage doors Mattapan MA homes need? Let us know whether the garage is detached and the route to it, the approximate size of the opening, the old door’s material and condition, whether there is an opener, and whether you already have a style in mind. Photographs of the door from inside and outside are useful if you have them. For new doors across the rest of the city, see our main new garage doors page, and our full local line-up sits on the Mattapan page. Next step: call us or book online.

Questions from Mattapan

Can a new door be fitted to an old detached garage?

Usually, yes. The opening is measured and its jambs, header, floor and headroom are checked first. Small irregularities can be allowed for; rotten framing or a serious lean needs dealing with before the new door goes in.

Does the old door’s hardware stay?

No. The old springs, cables, tracks and brackets are removed with the door, and the new door goes in with its own hardware sized for its weight and the opening.

Is a new door lighter than our old wooden one?

Generally, yes. A modern sectional door is usually much lighter than an old wooden door that has absorbed years of moisture and paint, which makes it easier on the springs and opener and easier to lift by hand.

Can we keep our existing opener?

Sometimes. If the existing unit is sound and suited to the new door, it stays, with its settings retuned. One that is ageing, labouring or missing working photo eyes is better swapped during the same visit.

Is it worth insulating a door on a detached garage?

That comes down to what happens in the garage. An unheated outbuilding gains less from insulation than an attached garage, though an insulated door runs quieter, flexes less and keeps a hobby space more comfortable.

Garage door stuck or refusing to open?

Book a repair visit, ask about a new garage door, or call us now. We answer 24 hours a day.

Schedule garage door service

Tell us what’s going on with your door and we’ll get back to you.

Schedule garage door service

Loading the form.

Elite Boston Garage Door Repair & Supply
590 Shawmut Ave, Boston, MA 02118
Hours: Open every day, 24 hours.