Garage Door Spring Repair for Mattapan, MA Homes

Broken torsion and extension springs replaced on the detached garages behind Mattapan’s single- and two-family houses, including older wooden doors still on their original spring setups. The phone is answered at any hour, every day of the week.
  • Open 24/7
  • Homes & businesses
  • 5.0 on Google

Schedule garage door service

Tell us what’s going on with your door and we’ll get back to you.

Loading the form.

What customers say about Elite Boston

Real reviews from Google.

Loading reviews.

Extension springs stretched along the upper tracks inside a detached single-car garage with an older wooden door

Why springs give out on the back-lot garages off River Street

Near Blue Hill Avenue and River Street, the typical house parks its car in an outbuilding behind it, reached down a driveway that is as long as the house is deep. When one of those doors suddenly feels far too heavy to move and the motor quits barely off the ground, garage door spring repair Mattapan MA homeowners need is nearly always the answer. A large share of these garages still carry older wooden doors on the spring setups they were given in the 1950s, and springs are the part of that hardware that wears out on a schedule of its own.

A spring is rated for a certain number of open-and-close cycles. Every trip up and down uses one of them, and a door that has been running for decades has usually been through more than one set already. Add a wooden door that has grown heavier with damp and repainting, and a spring working near the end of its life is lifting more than it was ever chosen for.

Without going near the hardware, three signs are worth looking for from the doorway:

  • A torsion spring above the header with its coils parted, or one of the long side springs hanging slack or in two pieces.
  • A loud bang from the garage, often in cold weather, with nothing else obviously wrong.
  • A door that the opener lifts a short way and then lowers again, or one that slams shut instead of settling gently.

What spring work covers here

Torsion springs that have parted

This spring is wound around a steel shaft mounted over the header. Once it breaks, the shaft no longer turns and the door is left with no lift at all.

Broken extension springs

Extension springs stretch along each side above the horizontal tracks. On older setups they may lack the safety cable that keeps a broken spring from flying loose.

Springs gone weak with age

A spring that is tired but unbroken lets the door drift down from half-open and makes the opener strain. It is often the first sign of a break to come.

Springs mismatched to the door

Earlier repairs sometimes leave a pair of different springs, or springs sized for a lighter door than the one hanging there now.

Pulleys and cables on spring doors

Extension-spring doors run their cables over pulleys that wear and seize. A spring job looks at them too, along with the cables covered on our Mattapan garage door repair page.

Torsion and extension springs on older doors

There are two ways a sectional door is counterbalanced, and both turn up on Mattapan garages. A torsion spring, or a pair of them, is wound onto a steel shaft running across the header above the opening. As the door closes, the cables pay off their drums and wind the spring tighter; as it opens, the spring unwinds and lifts the door with it. Extension springs work by stretching instead. They lie parallel to each upper track, anchored near the rear hanger and linked through a pulley to the lift cable, and they pull hardest when the door is fully closed.

On wooden doors fitted with 1950s hardware, extension springs are very common. They suit a garage where there is little room above the opening, and they were the usual choice for doors of that era. Their weak point is what happens when one breaks. A stretched spring that snaps releases its energy all at once, and without a containment cable run through its centre the broken end can lash across the garage, striking a car, a window or anyone standing nearby. Where an older door has no safety cables through its extension springs, that is worth putting right at the same visit, whether or not the spring has gone.

Torsion springs fail differently. The break usually shows as a clean gap a short way along the coil, and the spring stays on its shaft. The danger with torsion springs is in the winding rather than the break: the spring is loaded by turning it with steel bars inserted into a cone at one end, and a fully wound spring carries enough force to break a wrist or fling a bar out of a hand.

Leave torsion springs to us

A torsion spring holds dangerous tension whenever the door is closed, and it is not a DIY repair. It is not a part to loosen, adjust or replace yourself, and that remains true on a door that has already broken a spring, because the second spring on a two-spring shaft may still be fully wound.

The job looks simple from a ladder. Two set screws hold the winding cone to the shaft, and it can seem that loosening them would release the spring. What actually happens is that the spring unwinds in a fraction of a second, spinning the cone and anything attached to it. Fitting a new spring means winding it a precise number of turns for the door’s weight and height, with proper winding bars held in the correct sequence, and then setting the cables so both sides lift evenly. Getting any of that wrong leaves a door that drops, a door that flies up, or a spring that lets go while someone is standing under it.

Extension springs deserve the same respect. Unhooking one while the door is down means taking it off at full stretch. The safe way to change it is with the door raised and secured, the spring relaxed, and the cable and pulley set up again afterwards so that both sides match.

Heavier wooden doors and the springs that lift them

A spring is chosen by the weight of the door it has to balance. That is easy to get right on a new steel door with a known weight. It is less simple on a wooden door that has hung at the top of a Mattapan driveway for decades. Wood absorbs water and holds it, especially along the bottom section where rain and melting snow sit against it. Paint builds up in layers. Panels that split are often patched with plywood or a sheet of hardboard screwed over the gap. Every one of those adds weight that the original springs were never asked to carry.

The result is that a replacement spring cannot simply copy the old one. Garage door spring repair Mattapan MA owners have done properly starts with finding out what the door actually weighs now, by lifting it with the springs disconnected or by reading the balance once the opener is released, and only then choosing a spring to match. A spring chosen to suit the door as it is, rather than as it was, gives a door that stays put when it is let go halfway and an opener that is no longer straining on every trip.

There is a limit, though. Once a timber door needs very large springs to balance it puts extra load on its cables, drums, bottom brackets and hinges as well. If a door has reached that point, the visit will say so, and you will hear whether the springs alone are a sensible repair.

A technician measuring a torsion spring above a wooden overhead door in a detached garage

What a spring visit involves

Every garage door spring repair Mattapan MA garages get from us starts with the door, not the spring. With the trolley disconnected, the door is tried by hand, which shows how much lift is left and whether one side is carrying more than the other. Then the broken spring is examined to see where and how it failed, because a break near the cone points to age and a spring that snapped mid-length can suggest it was undersized.

Next the rest of the counterbalance is checked: the other spring, the cables, the drums or pulleys, the bottom brackets the cables are fixed to, and on an extension-spring door the clips and eye bolts holding each spring at the back of the track. Rollers and hinges are looked at too, because a door that binds in its track will wear out a new spring early.

You are told what has failed, what is needed and why, and the work only goes ahead once you have agreed. Where a door has two springs, both are normally replaced together: they have done the same number of cycles, and the survivor is likely to break before long. With new springs fitted and set, the door is balanced, the cables are checked for equal tension, and the opener’s settings are brought back down to suit a door that lifts properly again.

Garage door stuck or refusing to open?

Book a repair visit, ask about a new garage door, or call us now. We answer 24 hours a day.

Cold mornings and spring breaks

Springs are made of hardened steel wire, and like most steel they become less forgiving in hard cold. A worn spring that has been hanging on often chooses the first frosty morning of the season to snap, and the bang tends to come either overnight or the moment someone presses the button to leave for work.

Detached garages feel this more than attached ones. With no warm house wall alongside, the garage sits at outdoor temperature through the night, and so does every spring in it. Wet wood doors add to it: a bottom section that has frozen to the slab asks the spring and opener for more effort to unstick it, and that extra load can be the last straw for a worn spring. In winter it is worth checking that the bottom of the door is clear of ice before opening it, and stopping straight away if the door struggles.

A car shut in at the end of the driveway

The most common call that follows a broken spring is not about the door at all. It is about the car on the other side of it. Out in a detached building, with the street a driveway’s length away, there is no internal door to the house and often no other way out for the car, so a broken spring can leave it shut in.

Lifting a door with a broken spring is not a good idea. Without the spring, the door’s whole weight bears down on whoever is lifting it and on the opener if it is still connected, and if your grip slips the door comes down hard. Some doors can be raised with two people and propped, but only if the cables are still on their drums and nothing is bent, and propping a heavy wooden door is not a safe arrangement to leave. The better course is to pull the opener’s plug, let the door stay down, and call. Our phone is answered at any hour, and the Mattapan emergency repair page explains the first steps when a door quits at an awkward time.

Warnings before the break

Springs usually hint that they are failing, if you know what to look for. A door that once held still when stopped halfway but now drifts down, or one that lifts unevenly with one side leading, both suggest the springs are weakening or that one is carrying more load than the other. On a torsion spring, light can sometimes be seen between coils that should be touching. On extension springs, a spring that no longer pulls back fully, or one that has started to rust, is past its best.

The opener can tell you as well. One that has started to labour, slow down near the top of its travel or reverse for no clear reason may be fighting a door that has lost its balance. Rather than turning the opener’s force up to cope, which hides the problem and strains the rest of the door, have the springs checked. Our Mattapan opener repair page explains how the two are connected.

Looking after new springs

New springs last longest on a door that moves smoothly. After garage door spring repair Mattapan MA owners can do a few simple things to help, none of which involve touching the springs themselves. Through the winter, shovel the doorway first, so the opener never has to rip a frozen seal off the slab. Listen to the door: a new squeal, scrape or jolt usually means a roller or hinge needs attention, and a door that binds makes its springs and opener work harder on every trip. Watch how the door behaves when it is stopped halfway, and mention it if it starts to drift.

On a two-family lot where both units use the garage, the springs work through their cycles considerably faster than on a door used by one household. That is not a fault, but it does mean the springs on a shared garage are worth having looked at sooner. A wooden door also changes with the seasons as it takes on and loses moisture, so a door that was perfectly balanced in autumn can feel slightly different by spring. If it does, call us before the opener’s force setting is changed to compensate.

Extension or torsion: choosing what goes back

When an old extension-spring setup needs replacing, there is sometimes a choice to make. A like-for-like replacement keeps the door working as it always has, and with containment cables fitted it is a perfectly sound arrangement. On some garages, though, there is room above the opening for a torsion shaft, and a torsion spring gives a smoother, more controlled lift. Whether that conversion makes sense depends on the headroom in the garage, the condition of the door and the tracks, and what you want from the door, and it is something to discuss at the visit rather than decide in advance.

If the springs keep breaking because the door itself is past saving, the conversation may move to a new door instead. Our new garage doors in Mattapan page explains how an old wooden door and all its spring hardware are taken out together and a new door is balanced from scratch. Our main garage door spring repair page covers spring work citywide.

Booking a spring repair

To arrange the garage door spring repair Mattapan MA homes need, tell us whether you can see a torsion spring above the door or long springs along the tracks, whether there was a bang, where the door has come to rest, and whether a car is inside. Say if the garage stands apart from the house, which way it is approached, and if a side entrance exists. All our local services are listed on our Mattapan page. Next, call us or book online.

Questions from Mattapan

We heard a loud bang from the garage overnight. What happened?

Most often a spring has broken. From the doorway, hands off, check for parted coils over the header or a slack spring alongside the tracks. Leave it shut, disconnect the opener at the socket, then phone us.

Can I replace an extension spring myself if the door is down?

It is not a good idea. With the door down, an extension spring is at full stretch and stores a great deal of energy. Changing one safely means raising and securing the door first, then setting the spring, pulley and cable up evenly on both sides.

Should both springs be replaced when only one has broken?

Usually, yes. Both springs have worked through the same number of cycles, so the one that survived is likely to fail before long, and a new spring paired with a worn one can leave the door lifting unevenly.

Our old wooden door has no safety cables through its springs. Is that a problem?

It is worth fixing. A safety cable threaded through an extension spring holds the pieces if the spring breaks. Without one, a snapping spring can whip across the garage. Cables can be added when the springs are checked or replaced.

Why does our door slam shut even though the spring looks fine?

A spring can look intact and still have lost much of its lift, or one of a pair may have broken where it is hard to see. A door that falls instead of lowering steadily is out of balance, and it should be checked before it is used much more.

Garage door stuck or refusing to open?

Book a repair visit, ask about a new garage door, or call us now. We answer 24 hours a day.

Schedule garage door service

Tell us what’s going on with your door and we’ll get back to you.

Schedule garage door service

Loading the form.

Elite Boston Garage Door Repair & Supply
590 Shawmut Ave, Boston, MA 02118
Hours: Open every day, 24 hours.