New Garage Doors for South Boston, MA Homes

New garage doors supplied and installed, and worn-out doors replaced, sized to the tight openings of small rear garages behind triple-deckers and row houses and to the newer townhouse garages by the water.
  • Open 24/7
  • Homes & businesses
  • 5.0 on Google

Schedule garage door service

Tell us what’s going on with your door and we’ll get back to you.

Loading the form.

What customers say about Elite Boston

Real reviews from Google.

Loading reviews.

A new sectional garage door fitted snugly into a narrow opening on a small rear garage at the end of a driveway

Why older South Boston garages need a door made to fit

Choosing new garage doors in South Boston MA usually means working with a building that sets firm limits. Out back of the numbered streets’ triple-deckers and row houses, the little garages have narrow openings, low ceilings and walls close to the door, and many have carried more than one door before. Whatever replaces the old door must match the opening it actually has now, not the opening a standard door was drawn for.

The newer townhouse garages along the waterfront are a different case. The openings are usually square and modern, but the door is often on show to the street and in daily use as the main way in. There, the choice turns on how the door looks beside its neighbours, how it copes with damp air off the water, and how smoothly it runs many times a day.

Three measurements decide most of what will fit:

  • The width and height of the finished opening.
  • Headroom: how far the ceiling or lowest joist sits above the head of the opening.
  • The side room between each edge of the opening and the nearest wall.

What a new door involves

The door itself

Sections, finish, colour and windows chosen to suit the garage and the house. Supplied and installed by us.

Springs and hardware

Every new door comes with springs sized to its own weight, plus new tracks, rollers, hinges, cables and drums.

The opener

An existing opener may suit the new door; if it is worn, undersized or loud, a replacement is fitted at the same time.

Taking out the old door

We let the old springs down under control, then strip out the tired sections and rails to clear the opening.

Repair or replace: when a new door makes sense

Plenty of doors are worth saving. Moving parts are designed to be swapped out as they wear, and the door they hang on can outlast several sets of them. Our South Boston garage door repair page covers that side.

A new door is the better choice when the door itself is failing:

  • Steel sections rusted through along the bottom, or split along their seams.
  • Wooden panels gone soft, cracked across or swollen so the door binds.
  • A door so heavy with water or old repairs that its springs cannot balance it.
  • Several sections damaged at once after a knock, so that patching them one by one stops making sense.
  • A door you have simply had enough of: rattling, letting the wind in, or clashing with the building.

Most requests for new garage doors in South Boston start with one of these. Unsure where yours stands? Once we have seen it, we will give you a plain view. Sometimes a door that looks tired just needs new hardware and an adjustment.

Fitting a door to a tight older opening

In many of the small rear garages in this neighbourhood, the opening is not quite square. Timber framing settles, jambs get packed out over the years, and the header may sag a little in the middle. A new door has to sit square and seal along the floor, so we take the opening’s measure top, middle and bottom on both sides, and check level and plumb, before any door is ordered.

Headroom is often the tightest limit. Above the opening, an ordinary door wants room for its rails to bend toward the back of the garage and for the spring bar to be mounted. With a ceiling close to the door, the answer is usually a low-headroom track kit, or springs fitted in a different position. Each side of the opening also needs a strip of wall for the upright rails and the brackets that hold them, and in a garage with walls close to the opening, there is little margin.

The floor is the last piece. Older concrete or asphalt floors are rarely flat, and a new door’s bottom seal can only take up so much unevenness. Where the floor dips or rises, the seal and bottom section are chosen with that in mind.

Townhouse garages along the waterfront

The newer townhouse garages by the water usually have openings built to modern sizes, which makes fitting simpler. The questions there are different. A townhouse door often faces the street as part of a row of similar doors, and owners may want a door that keeps the row looking consistent. If your building has an association, it is worth checking whether it has any rules about door style or colour before choosing.

Exposure is the other question when weighing up new garage doors for South Boston townhouses. Damp, salty air near the water is hard on bare steel, so the finish, the hardware and how well the bottom seal keeps out water all deserve thought. A door that is in daily use as the main entrance also benefits from smooth, quiet running, which depends as much on the track, rollers and opener as on the door itself.

A new insulated garage door on a townhouse garage near the waterfront, with matching doors on the neighbouring units

Choosing the door

On a small building, the door is most of what you see from the driveway, and the choice is partly practical and partly about looks. The main decisions are these.

What the door is made of. For garages like these, steel sections are what most owners go for. They can be single-skin or insulated. Wood-look finishes give a traditional appearance without the upkeep of real timber, and real timber doors remain an option where the look matters most.

Insulation. An insulated door keeps a garage warmer in winter and quieter all year, and it is stiffer, which helps a wide door. It is also heavier, so it needs springs to match. Where the garage is used as a workshop or sits beneath living space, insulation is worth considering.

Windows. Glazing in the uppermost panel brightens a garage that has no other window. Our full view glass doors are another option for a modern look on a townhouse garage.

Colour and style. Panel patterns and colours vary. For an older row house or triple-decker, a simple panel door often suits best; for a townhouse, matching the neighbours may be the main concern.

We talk these choices through with you, with the measurements in hand, so the door ordered is the one that fits both the opening and what you want from it.

Garage door stuck or refusing to open?

Book a repair visit, ask about a new garage door, or call us now. We answer 24 hours a day.

Installation day

A new door is a bigger job than a repair, and the day runs to a plan.

Parking comes first. On the numbered streets, a van carrying door sections needs somewhere to stop, and a garage at the far end of a narrow driveway means every section, track and spring is carried in by hand. Please let us know about the driveway, any shared access and where a vehicle can park when we book.

At the garage:

  1. The old door’s springs are unwound safely and the old door, tracks and hardware come down.
  2. The opening is checked again and any framing that needs attention is dealt with.
  3. The new tracks are set plumb and level, and the sections go in one by one.
  4. Springs sized to the new door are fitted and set, and the cables are seated on their drums.
  5. The opener is fitted or reconnected and adjusted to the new door.
  6. Balance is checked by hand, the photo eyes are lined up, and the door goes up and down until it runs sweetly.
  7. Before we go, you get a walk-through of the controls and of the red cord that unhooks the door from the motor.

It helps to clear the garage around the door and along the walls before we arrive, and to keep the car out of the garage for the day. If anything is stored on shelves above the door, such as ladders, timber or boxes resting on the old track, take it down beforehand.

Bringing a door down a narrow driveway

A sectional door is delivered as a stack of separate panels, along with bundles of track, the spring shaft and boxes of hardware. That is good news for a garage at the far end of a slim driveway, because nothing has to be carried in as one long piece. Each section can be walked down the side of the house and stood against the garage wall until it is needed.

It still takes room. The panels have to rest somewhere flat and dry during the strip-out, and the driveway needs to stay clear long enough for them to be carried through. If a neighbour shares the driveway, a word with them beforehand saves a lot of shuffling of cars on the day.

What we find behind the old door

Taking an old door out of an older garage often reveals the state of the framing it was hiding. Jambs can be soft at the bottom where water has sat against them for years. The header may have sagged, or carry the holes and patches of several earlier installations. The stop moulding that the door seals against may be split or missing.

However good the door, it can only hang as straight as the timber it is screwed to, so anything found at this stage is shown to you before it is covered up again. Small repairs to the jambs or header are often part of making the new door hang true and seal properly. Where the framing needs more than that, we explain what we found and agree the next step with you.

New doors for shared garages

Behind a triple-decker, one garage may serve several units, and in a condominium the door may belong to everyone in the building. That brings a couple of extra decisions. The owners usually need to agree on the door before it is ordered, and the choice tends to lean toward a hard-wearing door that copes with heavy use rather than a delicate finish.

If the opener is replaced at the same time, every remote in use has to be programmed to the new one. It is a good moment to count the remotes, collect any that are no longer needed and make sure each unit has what it should.

Springs on a new door: why they matter

Every door has a weight, and the springs are chosen to balance exactly that weight. A new insulated steel door may weigh more or less than the door it replaces, so reusing old springs is never a good idea. Even where the weight is similar, old springs have already used part of their working life.

That is why a new door comes with its own springs, sized to it. Torsion springs on a new door hold dangerous tension from the moment they are wound, and setting them is part of the installation, never a job for the owner. A correctly balanced new door stays put when lifted halfway by hand with the opener released, and that is one of the checks we make before we leave.

The opener and a new door

A healthy opener can often stay on to drive the new door. If yours grinds, labours or has seen better days, swapping it during the installation saves a second visit, especially if the new door is heavier or the garage is used many times a day. In a low garage, the opener also has to fit in the space above the new door’s track.

We check the opener’s condition, its fit and its safety reversal as part of the installation. If it needs work or replacing, our opener work in South Boston page covers what is involved. Openers we install include LiftMaster models.

Keeping the weather out

One of the quiet benefits of a new door is a garage that stays drier. Older doors in rear garages often have a bottom seal worn flat or torn away, gaps down the sides where the jambs have moved, and a top edge that lets rain blow in. Leaves and grit collect along the floor, and in winter, snowmelt runs under the door and pools.

A new door is fitted with a fresh bottom seal shaped to the floor it closes on, and the perimeter is sealed against the stop moulding on the sides and top. Where the floor is uneven, the seal is chosen to take up the dips so the bottom edge meets the floor along its full width. On a garage near the water, where wind-driven rain is part of the weather, that seal matters as much as the door itself.

Good sealing also helps the door last for longer, and it keeps a stored bike, tools or boxes drier too. Water that sits against the bottom section is what rusts steel and rots wood, so keeping it out protects the new door from the very thing that wore out the old one.

Caring for a new door

A new door needs little attention, but a few habits keep it running well:

  • Once a season, look at the springs, cables and rollers for wear or rust, especially near the water.
  • Lubricate rollers, hinges and the spring coils lightly; leave the tracks clean and dry.
  • Keep the photo eyes clean and clear of obstruction.
  • Rinse salt and grit off the bottom section and seal in winter.
  • Call when the door starts to sound or feel different, rather than when it stops.

New garage doors in South Boston see the same weather, the same tight driveways and the same daily use as the old ones did, and a little care goes a long way.

Starting with a measurement

Every replacement begins with us measuring up and taking stock of the garage: headroom, side room, the floor, the framing and the route in from the street. After that, the choices that suit your opening can be talked through. For an urgent problem with your current door in the meantime, such as a broken spring or a door stuck open, see our South Boston emergency repair and South Boston spring work pages. How we supply and install doors across Boston is on new garage door installation, and everything we do locally is on the South Boston page.

Weighing up new garage doors in South Boston? Tell us a little about the garage, its opening and the way in, and call us first or book online.

Questions from South Boston

Will a new door fit our small rear garage?

In almost every case, yes. We take every measurement that matters, including the space above and beside the opening, and the door, track and springs are chosen to suit. A low ceiling may need a low-headroom track arrangement.

Can the old springs and tracks be reused?

No. A new door gets new springs sized to its own weight, and new tracks, rollers and hardware. Reusing worn parts on a new door shortens its life and can leave it out of balance.

Our townhouse is part of a row. Can the new door match the neighbours?

Usually, yes. Tell us what the neighbouring doors look like, or send a photo, and we can talk through styles and colours. If your building has an association, check its rules first.

Is an insulated door worth it?

It depends on how you use the garage. Insulation keeps the garage warmer and quieter and stiffens the door. For a garage used only for parking, a single-skin door may be enough.

Does our existing opener have to be replaced too?

Not always. If it is in good order and suits the weight of the new door, it can be adjusted and kept. If it is worn, loud or too weak for the new door, replacing it at the same time is usually sensible.

Garage door stuck or refusing to open?

Book a repair visit, ask about a new garage door, or call us now. We answer 24 hours a day.

Schedule garage door service

Tell us what’s going on with your door and we’ll get back to you.

Schedule garage door service

Loading the form.

Elite Boston Garage Door Repair & Supply
590 Shawmut Ave, Boston, MA 02118
Hours: Open every day, 24 hours.